Paul Horton's Welder Series

This is our #C005 universal Chevy motor mount kit. It is designed to hold the engine the way GM intended - not relying on the shear strength of the bolts going through the mounting tabs. It's easy ...

Welder Series assembly video for bars. Multiple uses - four bar kits, panhard bars, etc.
welderseries.com

I've revised my technique from the last video, and thought I'd show you how to assemble our Mustang II crossmember a bit faster. http://www.welderseries.com/blog/online-store/ws14540/

We've made a slight change to our sway bar kit to make it even more universal!

here's a (rather poor quality) example of tig welding pulses and puddles.

Here I assemble a Welder Series Mustang II kit. Ready to weld in about five minutes!

Join me! This is a pretty accurate color depiction of the arc.

P.S. Honestly, I didn't record in portrait.

You don't have to use floppy fingered gloves... I'll show you how to snug them up to give you a nicer, custom fit.

After we loosely dialed the timing in, this is one of the first few starts... it still needs a bit of tuning.
Edelbrock 600cfm carb, Edelbrock intake, Gibson headers, Flowmaster 2.5" dual exhaust w...

Replacing the tired, worn out hinge pins with brand new pins and brass bushings. The job was a bit more involved than I first thought...

Even though the splined end of our universal trim-to-fit sway bar kit has a set screw, the arm can sometimes work its way off the bar. I've got over 40,000 miles on the '32 without any movement by ...

Opening screen is supposed to say:
1968 Dodge D100
Mustang II Install
Video 4: Upper Towers and Shockwave mounting plates :)

Trimming the control arm upper towers and Shockwave mounting plates usi...